Here are some Tips on using the re-pick function in OneCNCXR3. Using geometry for the creation of boundaries in OneCNCXR3 tool paths are simplified for editing by allowing it to be re-picked and this is how it works.

This movie will show you tips of how to create geometry fillets in OneCNCXR3.

Here is a movie to give to you some tips on selecting chained geometry in OneCNCXR3. This applies to all versions of OneCNCXR3 although this tip movie only shows how it applies to OneCNCXR3 Lathe the same process is used for selecting chains in all products.

The same method of selection applies to other OneCNCXR3 versions