OneCNC-XP 5.46 is released if you require it after reading the details.

The only function modified in this update is the Incremental setting of the post.

If you like almost everyone else using OneCNC uses absolute programming this update is not required.
However for safety reasons it is recommended that you install it.

Note:
For safety we do not recommend you to use incremental automatic programming at any time unless you have a controller that does not have absolute programming.

The main reason being is very difficult to safely re-start a program for one and on many machines it can lead to dimensional problems in 3D parts especially.

OneCNCXP 5.45 is released please download.

Toolnotes now work like this:
Notes put into the tool notes is a one off note for that tool on that occasion. The tool note is not carried over or to another tool or even to the next tool in the program. It is always retained a a note for that tool on that occasion and of course can be edited using the edit procedure in the NC manager.

This means that when selecting a tool there are no notes in the notes unless you put them in.

New CAM Post Feature:
Cycles now accept variables for mid lines of cycles. There are some older controllers that require special variables as there are new controllers introducing variables for mid lines of cycles.

This function covers those situations.

One example of this is:
For a Philips Dialog 4 Control of the 1980's they need a variable number in front of the boringcyles for each line.

N10 N*1 G81 F140 S+800 Z-10.
N11 N*1 G00 X10. Y10.
N12 N*1 G00 X20.Y20.

This can be done by creating a new user variable and adding it to the cycle.
There are many other cases but this just describes one particular one.

OneCNCXP 5.44 is released please download

This update adds new methods of setting tool profile offset for the users with older controllers that have difficulty with cutter diameter offset. This now allows for automatic offset by OneCNC with the codes for wear size control assuming zero offset at the control.

The only values for diameter you would use at the control would be the adjustment for diameter wear or spring.

This completes all the additions to this OneCNCXP series.